Back
to Contents Page
Toshiba XM-6502B CD-ROM
Introduction
General Features | Drive Speed |
BUS
Interface |
Disc Formats |
Front Panel
General Features
Tray Loading Mechanism
3-way Disc Eject (eject button, software, emergency eject hole)
80ms Average Access Time
DAE (Digital Audio Extraction) Audio Capability
MPC3 Compatibility
Headphone Output Volume Control
top of page
Drive Speed
17.3X - 40X
BUS Interface
ATAPI
top of page
Types of Disc Formats Supported
Red-Book
Yellow-Book
CD-ROM-XA
CD-I Bridge (Photo-CD, Video CD)
CD-I
CD-I Ready
CD-G
Multi-session (Photo-CD, CD Extra, CD-RW, CD-R)
top of page
Front Panel
Figure 1.XM-6502B CD-ROM Front Panel
| Eject Button |
The EJECT button is used to open the disc tray so you
can install or remove a disc. |
| Busy Indicator |
When you install a disc into the CD-ROM drive, the BUSY
light flashes slowly as it attempts to locate the disc. One of the following will occur:
- BUSY light goes out. The CD-ROM drive is ready to read data from the
disc.
- BUSY light flashes slowly. The disc may be dirty.
- BUSY light remains ON. The CD-ROM is accessing data.
- BUSY light remains ON indefinitely. The CD-ROM is experiencing an
error
|
| Headphone Jack |
The headphone jack is used to connect headphones to
your CD-ROM |
Emergency Eject
Hole |
The emergency eject hole is to be used only when the CD
tray will not open when EJECT button is pressed. |
| Volume Control |
The volume control is used to adjust the level of the
audio signal from the headphone jack. The volume control does not affect the level of the
signal sent to the audio output on the back of the drive. |
| CD Tray |
Insert CD Disc in tray. |
top of page
|
