Back
to Contents Page
Toshiba SD-C2402 DVD-ROM
Setup
Installation Notes | Software Driver
Toshiba recommends
that only trained professionals install this DVD-ROM into your laptop/notebook.
Installation Notes
- The SD-C2402 DVD-ROM has no jumpers that need to be set
- Mounting orientation: ±15° (horizontally within back & front/right & left)
- When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of
drive.
- When mounting drive, the tightening torque of the four screws must be even. Recommended
screw tightening torque is 0.2Nm
- For clearance around the front bezel, it is recommended that a clearance of more than
0.8mm should be left in all directions.
Software Driver
Toshiba's CD-ROM and DVD-ROM drives do not require any unique device drivers for Windows
'95/'98/2000/NT. After installing your drive and re-booting, your system should recognize your CD-ROM or DVD-ROM.
Win '95/'98/2000/NT Operating Systems support all Toshiba ATAPI CD-ROM and DVD-ROM drives natively.
If you prefer using DOS, download the ATAPI driver from our web site.
top
of page
|
