Back
to Contents Page
Toshiba SD-R2102 CD-RW/DVD-ROM
Setup
Installation Notes | Software Driver
Toshiba recommends
that only trained professionals install this DVD-ROM into your laptop/notebook.
Installation Notes
- The SD-R2102
CD-RW/DVD-ROM has no jumpers that need to be set
- Mounting orientation: ±15° (horizontally),
±15° Vertically (volume control in down position), ±30°
(drive with volume control in up position).
- When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of
drive.
- When mounting drive, the tightening torque of the four screws must be even. Recommended
screw tightening torque is 0.2Nm
- For clearance around the front bezel, it is recommended that a clearance of more than
0.8mm should be left in all directions.
Software Driver
Toshiba's SD-R2102 drive does not require any unique device drivers for Windows
'95/'98/2000/NT/XP/Me. After installing your drive and re-booting, your system should recognize your
drive.
Win '95/'98/2000/NT/XP/Me Operating Systems support all Toshiba's ATAPI drives natively.
If you prefer using DOS, download the ATAPI driver from our web site.
top
of page
|
