Type 1 Light S – PUM11 CPU

 

Standard Sequence Control Module

The Type1 Light S CPU mounts in a standard V2000 I/O rack (3 I/O, 5 I/O or 8 I/O racks are available). It can replace a S2E module. The Type1 Light S does not support racks with station bus, or I/O modules that require a station bus.

 

Built-in Communication Options

The Type1 Light S CPU has both an RS485 port and an Ethernet port, which supports Toshiba’s ASCII computer link protocol. This allows connection by any HMI or SCADA software that has the Toshiba computer link driver. Also, Modbus® TCP/IP, Modbus® RTU, and direct communication with Toshiba LV VFDs.

 

Type1 Light H – PUM12 CPU

 

High-performance Sequence Control Module

The Unified Controller nv series™ TC-net™ I/O is built-in to the Type1 Light H CPU. It can be applied to I/O systems to provide enhanced performance. The master station, built into the CPU module, enables direct connection of the TC-net™ I/O loop. A 4 km-long loop remote I/O system than can be installed at low cost. The connected I/O can be selected from Integrated Controller V2000 series I/O (G2 I/O) or Unified Controller nv series™ TC-net™ I/O.

 

Remote I/O Configuration

The system collects and controls remote signals in real-time. The TC-net™ I/O is a high-speed, robust I/O system for optical cable communication with strong electrical noise resistance.

 

Type1 Light D – PUM14 CPU

 

Redundant Sequence Control Module

The Type1 Light D CPU supports redundancy. Redundancy enables greater productivity by providing the highest system availability. With a program capacity of 128K steps and the ability to connect up to 192 I/O modules, the Type1 Light D is ideal for critical medium and large-scale systems. The module can also be used in a single module configuration.

 

High Performance and Critical System Reliability

 Automatic switching to the secondary CPU occurs if a problem is detected in the primary CPU.

 

Software

• Free Tool
• Free Tool Registration
• Tool Updates